OBDSTAR X300 Classic G3 Key Programmer and DC706 ECU Tool can read and write Nissan Bosch CVT TCU253 R5F72539 TCM data by Bench and P004 mode. They have the same wiring diagram, and require OBDSTAR P004 Adapter and ECU Clone Jumper to connect device and Nissan TCM.
To perform the TCM reading and writing function successfully, please ensure the network connection is normal and 12V power supply is connected well during the operation, and follow the wiring diagram to connect OBDSTAR tool and TCM properly.
When using X300 Classic G3, need to activate ECU Clone License.
Menu function path:
Select ECU Flasher>> TCM>> TCM software (V30.31 or above)>> NISSAN BOSCH TCU-2–5–3 R5F72539
Wiring diagram:
ECUTOOLA-Pin M112V (16)A-Pin M4GND (4+5)A-Pin L4GND (4+5)A-Pin C2CAN L (14)A-Pin C1CAN H (6)
Connect OBDSTAR G3/DC706 and Nissan TCM correctly
After connection, turn on the switch button on OBDSTAR P004 Adapter, and select BENCH and P004
Start to connect ECU, read INT Flash & INT EEPROM (R5F72539), and write the original data into the new Nissan TCM.
Disconnect the ECU after writing.
Note: During the operation, follow the on-screen prompts to turn off or turn on P004 Adapter switch button.
OBDSTAR X300 Classic G3 clone Nissan TCU253 R5F72539:
OBDSTAR DC706 clone Nissan TCU253 R5F72539:
No comments:
Post a Comment